Freeze-Thaw

PIKUS TESTING DATA AND RESULTS

Pikus has tested the freeze-thaw in real weather conditions for four years. Testing data is collected from several Utah-based locations in seasonal outdoor weather. As part of the testing protocol, Pikus will ensure all freeze-thaw testing is done in the most extreme weather conditions for quality assurance. We test each batch of material with several different prints.

CATALOG

General testing over the course of 1 year of outdoor use.
Heavy-duty testing over the course of 4 years with fully finished products.
Testing with a variety of finishes and coatings resulted in consistent results.
Standardized testing throughout all projects.
Products are tested after two weeks of curing.
Testing results have shown 3DPG to have a higher performance level than regular concrete.

TESTING DETAILS:

Pikus Testing

DOWNLOADABLES AND EXTRA CONTENT

Here you will find access to aspects of Pikus testing data and useful information. If you would like access to information beyond that, please contact Pikus directly.

Downloads and Extras:

BIFMA Data

Safety Data

Warranty

Freeze-Thaw

Notable Results

Over the course of four years, PikusPrinted objects have shown to pass through several freeze-thaw cycles with little to no cracking or chipping. Minimal chipping may be present at the base of the structure if certain coatings are used.
Variations in print coating and internal supports have had varied results. Certain internal structures have expanded during freeze-thaw cycles, resulting in cracking. This is easily preventable with the latest PSM technology from Pikus. Coatings may vary the freeze-thaw performance. Not all coatings have been tested in real weather conditions.